Racer X (guest)  |
| Wed Jul 16, 2003 3:39 pm |
| i need to find a plastic ball |
the tubeing i got is a little on the big size of the carsb, it fits on tight enough but i doubt it seals it... i was thinking of getting a plastic ball(bigget than the opening of the carbs) and just dropping it down the middle.. that way you could easly check the sync.. no froth and quite easy to tell whitch one has more power.. also no more smoke when the oil get sucked up..
|
|
|
Ninja 250 First Service — C. J. Klingman, Wed Jul 16, 2003 12:18 pm -
Re: Ninja 250 First Service - 2nd Try — Tenchi4U, Wed Jul 16, 2003 5:57 pm
-
Re: Ninja 250 First Service - 2nd Try — C. J. Klingman, Wed Jul 16, 2003 7:22 pm
-
i need to find a plastic ball — Racer X, Wed Jul 16, 2003 3:39 pm
-
Re: i need to find a plastic ball — C. J. Klingman, Wed Jul 16, 2003 4:24 pm
-
I've done it w/o dampening... — kr, Wed Jul 16, 2003 2:25 pm
-
Re: I've done it w/o dampening... — C. J. Klingman, Wed Jul 16, 2003 3:32 pm
-
Re: dampening intake pulses — duke731, Wed Jul 16, 2003 12:52 pm
-
Re: dampening intake pulses — John, Wed Jul 16, 2003 1:45 pm
-
Re: dampening intake pulses — duke731, Wed Jul 16, 2003 3:31 pm