C. J. Klingman (guest)  |
| Wed Jul 16, 2003 7:22 pm |
| Re: Ninja 250 First Service - 2nd Try |
Yes, I wouldn't mind at all working with you on the valve adjust and carb sync, no charge. Some points:
1. I am retired and could do it anytime during the week, daylight hours. No weekend or night, these belong to my wife.
2. You sure on the tools? 10 and 12 mm combo wrenches for sure, 17mm socket (11/16) to turn crank, long skinny screwdriver for carb adjust, several feeler gauges less than 0.16mm (0.0063"), Kawasaki valve adjust tool, gas supply rig so can run motor without tank ( i.e. ~3/8" tubing and funnel), drill to remove spot weld (about 3/16"), some kind of hooks so can take off Kawasaki tubing clips, ty-raps to replace tubing clips, some means of measuring vacuum up to 6" Hg, ~3/8 tubing for gauge, etc.
3. I could furnish most of this stuff, although I'm sure I would forget something. I'm still very stiff from getting up and down a hundred times getting tools that I didn't have on the floor with me.
4. I've ordered a better feeler gauge set and better carb adjust tool that I should get within the next two weeks. They aren't necessary but would be nice to have if you don't have something adequate.
5. This would be mostly watching and talking on my part.
C. J. Klingman
Briarcliff, TX
|
|
|
Re: Ninja 250 First Service - 2nd Try — Tenchi4U, Wed Jul 16, 2003 5:57 pm -
Re: Ninja 250 First Service - 2nd Try — C. J. Klingman, Wed Jul 16, 2003 7:22 pm
-
i need to find a plastic ball — Racer X, Wed Jul 16, 2003 3:39 pm
-
Re: i need to find a plastic ball — C. J. Klingman, Wed Jul 16, 2003 4:24 pm
-
I've done it w/o dampening... — kr, Wed Jul 16, 2003 2:25 pm
-
Re: I've done it w/o dampening... — C. J. Klingman, Wed Jul 16, 2003 3:32 pm
-
Re: dampening intake pulses — duke731, Wed Jul 16, 2003 12:52 pm
-
Re: dampening intake pulses — John, Wed Jul 16, 2003 1:45 pm
-
Re: dampening intake pulses — duke731, Wed Jul 16, 2003 3:31 pm