Eric R (KeyMaster) View all posts in this topic  
Tue Aug 12, 2003 9:22 pm
Re: Ah, it's you!        

Well, it would be really simple to figure it out. Getting my hands on an uncut blank here is pretty much no problem, I go into one of my former places of employment and ask for one. They might charge me, but it's nice and cheap. Wink
I send it to you. You compare it with one of the ones you can get. I seem to remember you saying that yours are 0.25" too short? I think i'll try to remember to check my Ilco book tomorrow, maybe I'll be able to work it out through the cross references or find you a better alternative. This filing down the side milling on another blank seems a bit much...

 This topic is locked: you cannot edit posts or make replies. | Reply with quote | Return To Forum 
View next topic View previous topic

Powered by phpBB © 2001, 2005 phpBB Group