KDW (Regular) View all posts in this topic  
Fri Aug 19, 2016 1:56 pm
Step 1 - Clean & Order Parts        

The first thing that needs to be done is the carburetors need to be cleaned. You'll probably need to take them apart anyway so get them clean while it's easy.

The main jet needs to be reduced, since we'll be adding a second main fuel feed. The instructions suggest that reducing 2-3 sizes is a good starting point. When I spoke with Thunder Products they suggested that reducing 5 sizes has been successful for others. I've ordered both #100 and #102's. I'll start with the #100's and we'll see what happens.

Additonally, the older CVK-30's have a course thread drain screw, the IntelaJet kit comes with a fine thread drain screw. Course thread drain screws are available from Thunder Products so those are on order as well.

The other items that I needed to order were related to the carbs being old. O-rings and a couple of screws that had stripped heads.


 Post a Response | Reply with quote | Return To Forum 
View next topic View previous topic

Powered by phpBB © 2001, 2005 phpBB Group