anh3 (Lurker) View all posts in this topic  
Sun Apr 28, 2019 10:01 pm
more work        

chron wrote:
Not getting enough fuel - too much air, throttle blips and a/f ratio is out of whack like the plungers /diaphrams aren't putting the fuel out
maybe there is a little water left in the diaphram area from the cleanout ....


Pulled the carb today, double check reassembly. I have not touched the mixture screws, the metal cover plates for the mixture screws are still intact. This adjustment is needed then, it seems? At cold start it ran fine with choke, then after a minute it dies with either choke on or off; the same symptom, blip throttle RPM did NOT increase and it dies.

 Post a Response | Reply with quote | Return To Forum 
View next topic View previous topic


Powered by phpBB © 2001, 2005 phpBB Group