xbjornx (guest)  |
| Mon Jul 20, 2009 1:55 am |
| Kawasaki monster 250 |
In the beginning...
After the second time down it was clear that the plastics were garbage. Initially I just took the same concept as the ninjatard but with a 7inch round headlight and left most of the lower supporting frame.
Then I spun a bearing at 12k up a grade and had some down time to rethink my intended design...always loved the ducati monster. So I got a monster seat and tail light cheap off ebay and set to work
cut, mock-up, weld, '08 rear shock, lower triple tree on forks 1" and add clip-ons on top=
|
|
|
Kawasaki monster 250 — xbjornx, Mon Jul 20, 2009 1:55 am -
Garages — Howlzee86, Mon May 11, 2015 1:15 am
-
Good fabrication work on the back. Very nice. (n/t) — Bokonon, Mon Jul 20, 2009 8:11 pm
-
Re: Kawasaki monster 250 — AJinNoHills, Mon Jul 20, 2009 11:00 am
-
+1 on weight after chop.. might be some easier options — Urban Guerrilla, Mon Jul 20, 2009 12:15 pm
-
Re: Kawasaki monster 250 — xbjornx, Mon Jul 20, 2009 11:18 am
-
Typical scale locations... — BrianM, Mon Jul 20, 2009 6:09 pm
-
Re: Kawasaki monster 250 — AJinNoHills, Mon Jul 20, 2009 11:47 am
-
Re: Kawasaki monster 250 — rheglin, Mon Jul 20, 2009 3:00 am