LiL_RouD (Enthusiast) View all posts in this topic  
Sun Dec 26, 2021 12:42 am
Pulled and cleaned carbs, now no start, sometimes backfires        

Hi yall, I got a 2006 ninja. I bought it brand new in 2006 off the show room floor and it has about 8,000 miles on it. I let it sit over the past summer and it would start up and idle for the most part, even drove it around the block, It would die at stop signs if i had the chock off or didnt play with the throttle to keep it running so i decided to pull the carbs and clean them. I have done this same job atleast 2 other times since i owned the bike with no issues at all. This time it wont even start when I was done. I have pulled the carbs off more than 10 times to check my work, check the float adjustments, even pulled a carb off another working ninja 250 with the exact same results so i know its not the carb. Battery its 100% and new. When i try to start it it will sometimes have a sigle "quick" pop like a gunshot with a flash out of the exhaust and then nothing, just turning over non-stop. It sounded like it backfire on the intake side at one point but im not sure. I have pulled the plugs, checked for spark, even took valve cover off and checked the valve adjustments. I adjusted the valves at around 4000 miles for general service and it ran fine after that. Im about to lose my mind. The only thing I did different was I put silicone grease, very lightly, on the carb boots to aid my in sliding them back on, if this were I messed up??? Im wondering it silcone grease getting sucked into the intake valve is enough to ruin it or make it not seal? I really appreciate any help in advanced.

 Post a Response | Reply with quote | Return To Forum 
View next topic View previous topic

Powered by phpBB © 2001, 2005 phpBB Group